Avoid extending the axle in an extreme position with suspension at maximum droop.Sway bar bolt to Control Arm, 33 ft lbs.
#O2J TRANSMISSION BOLT SIZES PLUS#
#O2J TRANSMISSION BOLT SIZES INSTALL#
Install your NEW RAXLES in reverse order!! Be Careful, Make SURE you line up the splines on the end of the Raxles with the splines on your hub.Pull the OEM axles out through the wheel wells and clean all the old grease out of the transmission flange.Now use the 10 mm 12 point(Triple Square) bit again and finish removing the 6 bolts that hold the axle to the transmission.The OEM axle will now be resting on the Control arm and still attached to the transmission.Yes it will be hanging by the strut but that’s okay. Once the axle is pushed through the hub assembly pull the whole rotor assembly back and out of the way.Caution: On the right side, the axle may hold the spring in tension.While pulling out on the rotor use the gun to push out the axle through. If you have an Air Impact Hammer this makes it SO much easier. DO NOT at any time during this procedure rotate the rotor, it could damage the wheel bearings. While pulling out on the rotors hub use the Hammer and pointed chisel on the center of the OEM axle and drive it out of the hub of the rotor.Have your buddy hold the rotor so that it does not turn while you are loosening the bolts. This is where you will use the 10 mm 12 point (Triple Square) bit. If you are not using an Impact Gun during this procedure, now is a good time to loosen the bolts that hold the axle to the transmission.Remove 19 mm Nut that hold Tie rod ends to Control arms.Remove 13 mm bolts under control arm and behind the rotor.Swing Sway bar up and back to allow for easy removal of the OEM axles.Remove 16 mm sway bar bolt from Control Arm on both side of vehicle.DO NOT attempt this procedure without jack stands!!!! Lift front end of vehicle and place jack stands under car for support. Engage parking brake and secure rear wheels with blocks to prevent rolling. On flat level ground, turn car off and put car in Neutral.
0 kommentar(er)
